Printed Parts

Base

Springs

Retainer

Tray

Top 3

Step 1

Insert Springs into Base square holes as shown

Insert Retainer into Base over top of springs, there are 2 slots in base to hold retainer. This holds the springs in place.

Insert the Tray on top of the Springs. The is not required for thicker cards

Slide Top onto Base. Start at the end where the slot on the back of the base.

< Previous

Next >

To add business cards to the dispenser, slide top back about 3/4 of the way and add cards. Slide top back into place.

To dispense a card, push down on card from the back of the dispenser, and push forward about half way.

Printer: Rostock Max v2
Nozzle: 0.5mm
Filament: PLA (avg diameter 1.73mm)
Slicer Software: Slic3r 1.2.9
Bed Temp: 40° c
Nozzle Temp: 200° c
First Layer Height: 0.2mm
Layer Height: 0.15mm
Perimeter Width: 0.6mm
Ext Perimeter Width: 0.6mm
Solid Fill Width: 0.5mm
Notes
- Print both springs at the same time, let cool completely before handling. Handling before cooling will cause spring tension loss.
- Clean the slots on the base where the top slides on. There maybe strands of filaments that prevent smooth operation.
- Something I noted is that springs lose their tension in about 3 weeks. It will still work for about 15 cards, then doesn't work as smooth. I am going to printing them with PETG,